Mathew Nsiah

I first do estimate for the floor or wall to know the size about that particular place so that I can know the quantity of the tiles for that place

After that then I have to check that place if it’s good for me to tile then I have to sweep that place when it’s floor and I have to pour some water on it

After that too I will mix my adhesive after I finish mixing the adhesive then I have to set the tiles on the floor to check cutting sides will be the same or equal

Now if I get everything right then I will start spreading the adhesive on the floor where I set the tile then I put on the tile on the adhesive and I will use mallet to hammer it down

When I finish tiling it I have to leave it to dry when it dried the is time to clean it after cleaning then is time for grouting

Grouting means to fill the gaps between the laying tiles so you take grout and mix it with water and use spreader or I sometimes use rubber slippers and spread the mixing grout on the gaps between the tiles to make it looks there is no holes in it after that I have to wait for it to dry before I clean it again